gate signal

英 [ɡeɪt ˈsɪɡnəl] 美 [ɡeɪt ˈsɪɡnəl]

网络  选通信号; 门信号; 栅极信号; 门控信号; 闸信号

计算机



双语例句

  1. The core of optical reshaping is a decision gate featuring signal extinction ratio enhancement and noise reduction.
    信号整形的关键是光判决门,性能良好的判决门可以进一步提高信号的消光比、减小抖动。
  2. The noise gate is used to mute an audio signal once it falls beneath a set level for controlling background noise.
    噪声门可将要求的音频信号在强度低于所选电平时无声以提供背景噪声控制。
  3. To effectively gate sounds which have more decay after the initial transient, set the RELEASE control slow enough to allow the gate to remain open and capture the signal's entire envelope.
    为了有效地在起音阶段控制噪音保留较长时间的衰减,设置RELEASE旋钮足够的慢,以至于充许噪声门打开,使其原始信号可闻。
  4. Improvements and Simulation of High-power GTO Gate Trigger Signal
    大功率GTO门极触发信号的改进与仿真
  5. Under the condition of gate signal coming from 32 bit presettable timer, it is more convenient in design of applied circuit.
    闸门信号采用32位可预置定时器,使电路在应用设计中更为便捷。
  6. The possibility of high repetition rate laser interference with semi-active laser guided weapons operating based on real time gate signal was studied. The parameters, such as the laser interference frequency, output power were analyzed, and the interference measures, assistant systems were presented briefly.
    研究了高重频激光器对于干扰实时波门选通信号半主动激光制导武器的可能性,分析了激光器的干扰频率、输出功率等参数指标,并且对干扰措施、辅助系统等进行简单介绍。
  7. Analysis of High Repetition Frequency Laser Interference with Real Time Gate Signal
    高重频激光对实时波门选通信号干扰的分析
  8. The implementation of online power quality monitoring system based on the parallel data processing structure of field programmable gate array ( FPGA) and digital signal processor ( DSP) is proposed.
    提出了基于现场可编程门阵列器件FPGA与数字信号处理器DSP并行结构的在线电能质量监测与分析。
  9. The phase detecting error caused by local oscillator frequency drift and non-synchronization of measurement signal and gate signal is eliminated and the measurement speed is improved at the same time.
    该方法可以有效的消除因本振信号频率漂移及闸门信号与被测信号的非同步引起的测相误差,同时提高了测量速度。
  10. An application of MATH on deducing the nonlinear coupling differential equations of the BJT-Not gate, which is stimulated by rectangle pulse signal and is developed from Ebers-Moll equations is presented.
    从Ebers-Moll方程组出发,建立在矩形脉冲激励下的BJT反相器的非线性耦合微分方程.介绍了MATH程序语言在求解逻辑门开关电路的非线性耦合微分方程中的具体应用。
  11. Abstract:: The application of CMOS Transission Gate to the signal generation, translation, control and observation, etc. are discussed.
    本文提出了CMOS传输门在信号的产生、变换、控制和观测等方面的应用。
  12. The acoustoelectric current also reveals Coulomb Blockade as a function of split gate voltage when microwave signal with the resonance frequency is coupled to DDT.
    给叉指换能器耦合共振工作频率微波后,我们观察到声电电流随分裂栅电压的变化同样出现库仑阻塞。
  13. Analysis of Laser Guidance Weapon's Real-time Gate Signal Choosing Technology
    激光制导武器实时波门选通信号技术分析
  14. The Design of Ternary Quad state Gate CMOS Circuits Based on Switch signal Theory
    基于开关信号理论的三值四态门的CMOS电路设计
  15. According to the different demands of test/ operation of the supply, a PIC micro controller based Gate signal generator is designed.
    根据ECRH系统在调试和运行状态对高压脉冲电源的不同要求,设计了基于PIC单片机的Gate信号发生器,该发生器设置方便,使用灵活;
  16. Serial port communication was achieved by adopting VC++ program, which was used in controlling power's "on/ off", gate signal's" on/ off", PWM ( Pulse Width Modulation) percentage and PWM frequency.
    该方案是采用VC++编程实现串口通信(SPC),用于控制激光微焊接中激光能源的开关、门信号的开关、PWM百分比和PWM频率。
  17. In order to verify the theoretic derivation, amplitude characteristics of the device are measured by network analyzer and disposed by gate function for triple-transit, quintuple-transit signal.
    采用网络分析仪测量了S型声表面波器件的幅度特性,同时,由门函数处理后获得其三次和五次渡越反射信号的幅度特性以验证理论推导的正确性。
  18. Appending a veto control and a gate signal amplifier in the circuit, MCA can be operated in both pile-up rejection mode and anticoincidence mode.
    电路内附反符合控制输入和门信号放大器,可实现对多道分析器的堆积拒绝和反符合控制。
  19. Analysis on the Causes of the Failure of Ring Gate Jam Signal in Xiaolangdi Hydropower Station
    小浪底水电站筒阀发卡信号出现原因分析
  20. A pulse counting with gate controlling, if the relation of gate signal and counting signal is random, the quantized taking values and quantized errors follow a bi point distribution, while the arithmetic means of repeated measurement follow a binomial distribution;
    对于门控脉冲计数,若门控信号与计数信号间的关系是随机的,则量化取值和量化误差遵循二点分布,多次测量的算术平均值遵循二项分布;
  21. That using advanced nimble field programmable gate array ( FPGA chip) gathering, processing signal in design, fully displaying its formidable I/ O function as well as the field programmable capability, has greatly reduced the time for product development.
    采用先进灵活的现场可编程门阵列即FPGA芯片来进行信号的采集、处理,充分发挥了它强大的I/O功能以及现场可编程功能,这大大缩减了由于产品升级换代带来的更改硬件电路的时间。
  22. The advanced technologies have improved transistors switching rate, and reduced transistor gate delay. However, signal transmission and power consumption are getting worse due with the global wire delay.
    先进微电子与半导体工艺技术极大地提升了晶体管翻转速度,降低了门延时,但是芯片中全局线时延导致的信号传输与功耗问题却变得越来越糟糕。
  23. By sampling the output voltage, the system can control the oscillator frequency to stabilize the output current; or according the feedback voltage, the system can decide the number of skip cycle of the power transistor gate signal to stabilize the output voltage.
    系统通过对输出电压的反馈采样,控制内部振荡器的频率,使输出电流恒定;或根据反馈电压,调整功率管栅信号的跳周期个数,使输出电压恒定。
  24. SCR replaced the used gap ignition switch, is characterized by high-voltage capability, the gate signal microcomputer control system FM.
    用晶闸管替代了以往的间隙点火开关,采用高压晶闸管系统来做开关,其特点就是能耐高压、门极信号采用微机控制系统进行调频。
  25. The complete synchronous digital frequency measurement method has thoroughly eliminated the positive and negative 1 number-counting error, because it has realized the synchronization of the measured signal, standard signal and the real gate signal.
    在全同步测频法中实现了被测信号、基准频率信号和实际闸门信号的全同步,彻底消除了±1个字的计数误差。
  26. Usually, a current pulse is applied to the gate for the measurement. A novel gate charge testing circuit is presented in this thesis. The influence of control signal on gate input current is eliminated for the control signal is input from the source of the MOSFET.
    本文提出一种新型栅电荷测试电路,该测试电路使控制信号从MOSFET的源极输入,消除了控制信号对栅极输入电流的影响。
  27. Multi-period synchronous frequency measurement method realized the synchronization of gate signal of frequency measurement and the measured pulse signal, eliminating the measured signal error of ± 1 counts.
    多周期同步测频法由于实现了测频的闸门信号与被测脉冲信号的同步,消除了被测信号的±1个计数误差。
  28. Many current software radio platforms are based on either programmable hardware such as field programmable gate arrays ( FPGAs) or embedded digital signal processors ( DSPs).
    目前,很多软件无线电平台都是基于可编程硬件实现,如现场可编程门阵列或嵌入式数字信号处理器。